Pipeline Design for Water Engineers

David Stephenson (Eds.)9780444414175, 0-444-41417-7

“… the book is at its best in the design and analysis sections and could stand on these alone as a well-stocked handbook with copious references for further study,” commented the Journal of the National Water Council after publication of an earlier edition of Pipeline Design for Water Engineers.
This classic monograph has been revised and updated to take account of new developments in the field. Recent research in cavitation and flow control has prompted additional sections to be added. There are also new sections on supports to exposed pipes and secondary stress. Additional references and a new layout make up this edition. Some sections appearing in previous editions, noteably on pipe network systems analysis and optimization have been ommitted as they were considered more appropriate in the author’s parallel book “Pipeflow Analysis” (Developments in Water Science, 19).

---

Table of contents :
Content:
Advisory editor
Page ii

Edited page
Page iii

Copyright page
Page iv

Preface
Page v

Acknowledgements
Page vi
David Stephenson

Chapter 1 Economic Planning
Pages 1-12

Chapter 2 Hydraulics
Pages 13-26

Chapter 3 Pipeline System Analysis and Design
Pages 27-52

Chapter 4 Water Hammer and Surge
Pages 53-83

Chapter 5 Introduction To Solids Piping
Pages 84-95

Chapter 6 External Loads
Pages 96-111

Chapter 7 Concrete Pipes
Pages 112-125

Chapter 8 Steel and Flexible Pipe
Pages 126-138

Chapter 9 Secondary Stresses
Pages 139-155

Chapter 10 Pipes, Fittings and Appurtenances
Pages 156-174

Chapter 11 Laying and Protection
Pages 175-194

Chapter 12 Sewers
Pages 195-201

General References and Standards
Pages 202-209

Appendix
Pages 210-214

Author Index
Pages 215-216

Subject Index
Pages 217-222